Scotts Super Turf Builder with Plus 2 Weed Control, now called simply Super Turf Builder with Weed and Feed, contains more nitrogen and phosphorus than plain Turf Builder Weed and Feed, to provide faster green-up. Super Turf Builder contains 29 percent nitrogen, 2 percent phosphorus and 3 percent potassium, while plain Turf Builder contains 28 percent nitrogen, no phosphorus and 3 percent potassium. The active weed-killing ingredients are 2,4-D and mecoprop. Environmental health agencies in some areas list 2,4-D as a chemical known to cause cancer or birth defects, so use with caution.
Healthy Lawn Chemistry
If you have a very small lawn, an alternative to the granular Scotts weed and feed products is the Scotts Liquid Turf Builder with Plus 2 Weed Control. This liquid fertilizer provides a quick boost of nitrogen as well as killing clover, dandelions and other weeds. Simply attach the garden hose and spray the lawn when the weeds are actively growing.
Scotts Turf Builder Plus 2 Liquid
A well-kept, healthy lawn should be plush, free of weeds and diseases, and as green as the neighbors’ envious hearts. Weed and feed products are designed to provide needed nutrients to the grass while poisoning weeds that want to steal the lawn’s food. Scotts Super Turf Builder with Plus 2 Weed Control works on several species of lawn grasses. While the company’s website recommends waiting four weeks to put down grass seed after applying the weed and feed, seeding first means waiting a different length of time before you use the product.
Since weed and feed products are designed to prevent germination — or to eradicate a living plant — they can, for the most part, have a similar effect on young turf grass. The only exception is the pre-emergent herbicide siduron, which is actually used to assist in seed germination. When using a pre-emergent that does not contain siduron, wait a minimum of two months before seeding. If using a product designed for broadleaf weeds, read the label carefully, because the active ingredient in these post-emergent herbicides have a wider range for the waiting period. Grass can be planted in as little as one month after application for products using 2,4-D to as much as six months for atrazine-based products.
You want a beautiful lawn for your family to enjoy, but it’s no longer enough to just mow it. You have to fertilize, water, kill weeds and then reseed any bare spots. Using a weed and feed product saved you some time, so now you’re ready to plant some grass seed. You may have to wait a bit longer, though, depending on the type of weed and feed product you used.
Pre-emergent weed and feed is applied in early spring so the herbicide is in place before the undesirable weeds germinate. Pre-emergent herbicide works by inhibiting germination. It must be watered with at least one-half inch of water to move the chemical from the surface into the soil. Post-emergent herbicides, however, must be applied while the weeds are actively growing because for the chemical to work, the herbicide must be absorbed into the plant.
Weed and feed products consist of fertilizers such as nitrogen or potassium, and a pre-emergent or post-emergent herbicide. If the weed and feed is designed for spring application, it contains a pre-emergent. If it is designed for later in the growing season, it incorporates a post-emergent herbicide. Knowing which one you are using is important because the herbicides affect plants in significantly different ways.
Why You Wait
When you are ready to seed your lawn, use a garden rake to remove debris and to break up the surface to ensure the seed comes into contact with the soil. Broadcast the seeds in two directions to ensure complete coverage, and water the ground lightly and often for up to two weeks — keeping the soil moist. Once seedlings have established, gradually reduce the frequency of the watering, but lengthen the amount of time per watering. This will encourage a deep root system for your grass.