Before you purchase any equipment, it is important to understand the possible limitations of an indoor garden. Consider the height of the ceiling, how much insulation your space offers, and your ease of access to electricity and water. Some local jurisdictions may also ask that indoor gardens mitigate odors during the flowering phase.
Nutrient Film Technique (NFT) is another recirculating system in which plants are suspended by net baskets or neoprene collars that run along a trough. A thin film of water and nutrients continually circulates through the bottom of the trough, providing food to the tips of the roots, while leaving a majority of the root mass exposed to air.
High-pressure sodium (HPS) bulbs are highly efficient HID lights that produce a very effective spectrum of light to promote growth during the flowering phase. Most HPS bulbs are double-ended and can last 10,000 hours without losing efficiency. While these lights are the workhorses of most grow rooms today, they produce a significant amount of heat that needs to be removed, increasing air conditioning requirements.
If you’re a beginner, prefabricated grow tents are a great option, as they allow for minimal wear and tear on your property. Instead of renovating or building a new room, grow tents can be set up and taken down in a matter of minutes while also providing a clean, reflective, and enclosed environment for your plants to grow. As a general rule, your ceiling height should be at least a height of 8 feet, or about 2.4 meters; this is the typical height of a tent. Check your prospective tent’s measurements before committing to the purchase.
Setting up your grow: choosing a space
Choosing the right horticultural lighting for your indoor grow can mean the difference between success and failure. Correct lighting is crucial, as it drives photosynthesis. In other words, your plants will not grow properly without proper lighting. The duration of your lighting controls the photoperiod, or the times in which a grow is exposed to light. During the vegetative growth phase, plants need a minimum of 16 hours of light. The most common schedule during this phase is 18 hours of light and six hours of darkness. To initiate flowering, plants need a shorter day, with 12 hours of light and 12 hours of darkness.
Though the 12-hour interval is fairly universal, knowing exactly when to induce flowering is less clear. For the home grower, it usually comes down to space; the longer one waits to trigger the flowering cycle, the taller their plant will be. A good rule of thumb: cannabis will only continue to grow 30 to 50 percent once the light source is reduced. If the plant is growing in a closet, growers should trigger the flowering cycle, understanding that there must be more than two feet of space between the canopy of the plant throughout the entirety of its life.
While most, if not all, medical and recreational farms cultivate cannabis from seeds, guaranteeing that their plants are free from viruses, most home growers, even those with experience, typically begin with clones — essentially trimmed pieces of female cannabis plants that have been rooted in separate pots. “When most people think of cannabis — you know, what you smoke — they’re thinking about the flowers of female plants,” Lipton said. “When you grow from seeds, half of them will be males. If you’re only going to do one or two plants, you don’t want to waste your time with that stuff.” A clone sourced from a dispensary or a knowledgeable friend guarantees that the plant is female and will eventually produce bud pending proper care. “You can get up to four ounces off the right plant — if you know what you’re doing.”
To harvest, many growers begin by removing the leaves of the cannabis plant with trim scissors, followed by the buds (using pruners). “We call this bucking,” Lipton said. “Gloves are also extremely important for sanitation reasons as well as to keep your hands from becoming sticky with the resin from the plant.”
After 55 to 60 days, growers begin paying close attention to their plants’ trichomes — the small, bulbous fibers that develop around the flower of the female plant. “Those trichomes will turn from clear to amber,” Lipton said. “They kind of look like red hairs. You know it’s time to harvest when about 10 to 15 percent of the trichomes turn that color.” On average, cannabis plants have a five- to seven-day window of peak harvest time.
Trigger the flowering cycle.
To understand the flowering cycle, it’s important to remember that cannabis is a plant. And, like most plants, it follows the seasons. To trigger flowering — which will take 55 to 60 days to complete — growers reduce the time plants spend exposed to the light source from 18 hours to 12. “You’re basically telling your plant it’s mid-September,” Lipton said.
pH of Water: 6.3 to 6.7. “You’ll need a meter that you can stick into your water and tell you the pH,” Lipton said. “You want something between 6.3 to 6.7 pH for watering your plants. That sounds like pretty sophisticated stuff but it’s really not. A lot of times your tap water will be 7.8. You can use what they call pH down. That’s a crucial step.”
Space: 3 x 3 x 5 feet, minimum. “The bigger the space, the better. With all the lights, closets get hot,” Lipton said. That said, closets help growers control light pollution when the plant is in its flowering cycle — one of the main reasons home growers favor them over larger spaces, such as living rooms. “If you have a spare bedroom, or a basement even, you can just use that and close the door,” Lipton said.
Know the law.
Presented by Florida Man DIPA
Sticking to that schedule is key, he added. “Say you’re at day 30 of the flowering cycle and you come into that closet when it’s supposed to be dark and turn a bunch of lights on. You’re going to throw the whole cycle off and that’s the end of that. It only takes 10 seconds.”