Posted on

growing female weed plants

Growing female weed plants

To harvest, many growers begin by removing the leaves of the cannabis plant with trim scissors, followed by the buds (using pruners). “We call this bucking,” Lipton said. “Gloves are also extremely important for sanitation reasons as well as to keep your hands from becoming sticky with the resin from the plant.”

Though the 12-hour interval is fairly universal, knowing exactly when to induce flowering is less clear. For the home grower, it usually comes down to space; the longer one waits to trigger the flowering cycle, the taller their plant will be. A good rule of thumb: cannabis will only continue to grow 30 to 50 percent once the light source is reduced. If the plant is growing in a closet, growers should trigger the flowering cycle, understanding that there must be more than two feet of space between the canopy of the plant throughout the entirety of its life.

Cannabis plants yield the highest-quality (and quantity) flowers after maturing. This usually takes about a month to happen. “I recommend planting in a five-gallon Home Depot bucket,” Lipton said. “It’s really important to have proper drainage, so you want to drill some holes in the bottom. The biggest mistake people make is that they overwater and suffocate the roots. Cannabis likes to be watered and dried out before it’s watered again.” During the vegetative cycle, the plant should be exposed to a minimum of 18 hours of light. Remember to open the closet door while the lights are on to prevent the space from heading north of 78 degrees Fahrenheit.

pH of Water: 6.3 to 6.7. “You’ll need a meter that you can stick into your water and tell you the pH,” Lipton said. “You want something between 6.3 to 6.7 pH for watering your plants. That sounds like pretty sophisticated stuff but it’s really not. A lot of times your tap water will be 7.8. You can use what they call pH down. That’s a crucial step.”

Harvest and cure.

To understand the flowering cycle, it’s important to remember that cannabis is a plant. And, like most plants, it follows the seasons. To trigger flowering — which will take 55 to 60 days to complete — growers reduce the time plants spend exposed to the light source from 18 hours to 12. “You’re basically telling your plant it’s mid-September,” Lipton said.

It’s important to remember that cultivating even one cannabis plant for personal consumption is felony on the federal level and punishable by up to five years in prison. Meanwhile, four US states — Alaska, Colorado, Washington D.C. and Oregon — have passed local amendments, allowing citizens who are 21 years old and over to grow a limited number of plants without fear of persecution.

Despite the hurdles, many first-time growers still choose to cultivate cannabis indoors (which is legal in Alaska, Colorado, Washington D.C. and Oregon), and there are steps to maximize a plant’s chances of succeeding. It all starts with a plant’s genetics. “For your typical closet setup, you’re going to want a plant that stays short,” Lipton said. “A lot of time that means an indica. Sativas are really tall and lanky.” (More on the difference between those two families here.)

Trigger the flowering cycle.

While most, if not all, medical and recreational farms cultivate cannabis from seeds, guaranteeing that their plants are free from viruses, most home growers, even those with experience, typically begin with clones — essentially trimmed pieces of female cannabis plants that have been rooted in separate pots. “When most people think of cannabis — you know, what you smoke — they’re thinking about the flowers of female plants,” Lipton said. “When you grow from seeds, half of them will be males. If you’re only going to do one or two plants, you don’t want to waste your time with that stuff.” A clone sourced from a dispensary or a knowledgeable friend guarantees that the plant is female and will eventually produce bud pending proper care. “You can get up to four ounces off the right plant — if you know what you’re doing.”

Even with a healthy clone, however, cultivating cannabis can be a long and arduous process — especially in tight indoor spaces. “A lot of people think growing is easy, but it’s not,” Lipton said. “You have to be really on it. Not everyone has success, obviously.”

Female cannabis plants receive pollen from males to produce seeds, which will carry on the genetics of both plants to the next generation.

When determining the sex of a cannabis plant, pre-flowers, or the beginnings of male and female sex organs, will appear at the nodes.

A node is a point at which a branch grows off of the main stem, or one branch from another branch. Fan leaves and buds can grow on some nodes, but not necessarily all.

Trichomes

Male plants can also be used for:

Cannabis is a dioecious plant, meaning it can be male or female, and the male and female reproductive organs appear on different plants. What’s in your stash jar now are the flowers of a female marijuana plant.

A bract is what encapsulates the female’s reproductive parts. They appear as green tear-shaped “leaves,” and are heavily covered in resin glands which produce the highest concentration of cannabinoids of all plant parts.

Roots

Males are important in the breeding process, but that is generally best left to expert breeders. When pollinating females, males provide half of the genetic makeup inherited by seeds.

Growers can ensure the sex of their plants by growing clones or the genetically identical clippings from a parent strain. Feminized seeds are also made available through a special breeding process.